One thing I have yet to try is use a different sd card (in the eventuality it encounters some weird read error), but I don’t have one right now. In both cases I have attached a display to the pi and watched the boot process carry on without issues. When they don’t, whenever I run sudo systemctl start rvice it gets stuck without any output and status shows Active: inactive (dead). I cannot pinpoint the specific reason why the services either work or they don’t. I’m also running the latest version of OpenMediaVault 6. PRETTY_NAME="Debian GNU/Linux 11 (bullseye)" Now the services ( argononed, argoneond) sometimes start, sometimes they don’t. This gets stuck after created symlink, exactly as before.Īfter trying lots of things, multiple uninstall/reinstall attempts, I managed to install your updated script. Smartmontools is already the newest version (7.2-1). I2c-tools is already the newest version (4.2-1+b1). Python3-smbus is already the newest version (4.2-1+b1). Python3-rpi.gpio is already the newest version (0.7.0-0.2+b2).Ġ upgraded, 0 newly installed, 0 to remove and 0 not upgraded. Now, when I try to install the argoneon.sh script, I run into the same issue. After moving my pi to from the M2, I’ve run argon-uninstall, rebooted. Sudo python3 -i /usr/bin/argononed.py SERVICE but doing this on every boot is not a solution. LE4: It appears I am able to start the service manually by running rvice - Argon One Fan and Button Service Loaded: loaded (/lib/systemd/system/rvice enabled vendor preset: enabled) Active: inactive (dead).LE2: Shouldn’t there be an /etc/argon folder? LE: sudo systemctl restart rvice or sudo service argononed start don’t do anything I had hopes that my backup image would work, but it seems fan control was already broken when I last updated my backup. I mention this because I’ve seen this suggested in another post. I’m running OpenMediaVault and I really, really don’t want to burn a new sd image and go through the whole installation/configuration process again. I’ve tried uninstalling/reinstalling the script, but if I do that the installation also gets stuck afterĬreated symlink /etc/systemd/system//rvice → /lib/systemd/system/rvice. When looking inside /etc/nf, the values are updated, but nothing happens when those temps are reached. I’ve run argonone-config again and after inputting the values, it gets stuck and I must forcibly close it. So today I ran a stress test and it seems the fan control stopped working. I’ve noticed the past few days my pi was unusually quiet.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |